The Metta (4)Previous Page
Continue with this pivoting process up the centre back using his previous section as a guide.
Repeat this process on the opposite side.
Return to the first side and continue with this process up to the crown and then through into the front hairline using appropriate elevation.
As you reach the top sections over-direct back to maintain your initial guide through the front sections.
Repeat the same process on the opposite side.
Now, take a curved section approximately 4 to 5cm thick around the whole of the head leaving out the perimeter. Elevate this section using the interior shape as a guide and connect from the front to the back refining corners.
Repeat this process on the other side.
Continue to work this process with parallel circular sections, which refines the shape. Cut only very small amounts of hair to refine.
Cross check the crown area.
Refine the outline shape through the sides with a pointing technique.
Stacey's result, a perfectly tailored shape demonstrative of method, accuracy and excellence.